Home

The Current Local Date and Time in Goto, Japan (JP)

Time Zone Asia/Tokyo

17:18:56

Local Time Date and Timezone

Where is Goto? (Japan, JP)

Goto is a city located in Japan (JP).
Latitude 32.68418 Longitude 128.8068

Goto location on the Japan (JP) map

Information about Goto

City: Goto
Country: Japan (JP)
Latitude: 32.68418
Longitude: 128.8068
Time Zone: Asia/Tokyo

Time zone and UTC offset ofGoto

Goto, Japan is in the Asia/Tokyo time zone, which is currently UTC+9. Daylight saving time is not observed in this time zone, so the offset stays the same all year.

Current time difference with other cities

Goto is 8 hours ahead of London
Goto is 13 hours ahead of New York
Goto is 16 hours ahead of Los Angeles
Goto is 5 hours ahead of Dubai
Goto is 2 hours behind Sydney

Frequently asked questions about time inGoto

What time zone is Goto in?

Goto, Japan is in the Asia/Tokyo time zone (currently UTC+9).

Does Goto observe daylight saving time?

No, the clocks do not change during the year in this time zone.

What is the time difference between Goto and New York?

Goto is 13 hours ahead of New York (the difference can change when either place switches to or from daylight saving time).

What are the coordinates of Goto?

Goto is located at latitude 32.68418 and longitude 128.8068.

Sunrise, sunset and moon phase inGoto today

Astronomical data for October 16, 2026 in Goto, calculated for the Asia/Tokyo time zone. All times are local.

Sun

Sunrise: 06:29
Solar noon: 12:10
Sunset: 17:51
Length of day: 11 h 22 min

Moon

Moon phase: Waxing Crescent
Illumination: 29%
Moon age: about 5.3 days
Moonrise: 11:43
Moonset: 21:24

Other cities inJapan

All cities and towns in Japan

City of Goto

In computer programming, goto is a control flow statement that transfers control to another line of source code. Unlike a function call that supports returning to the point of call, goto does not. The statement is denoted differently by programming language; some use lowercase (goto), some use uppercase (GOTO), and others are case-insensitive. A few languages make the statement two words (i.e. GO TO). A goto statement is included in a language, primarily, to provide access to the machine code jump instruction (a.k.a. branch or transfer), but due to potential problems with the use of jump semantics, languages have over time been augmented with other flow-control mechanisms intended to replace the need for and use of goto. Many modern languages do not include a goto statement at all. Many languages that do include a goto statement restrict its use in order to limit the problems that its use might incur. Further, as its use is generally considered a poor choice, software developers tend to avoid using it even when using a language that provides it. In general, use of goto is considered a poor choice as it leads to code with higher cognitive load and more bugs than code that uses more structured flow-control. The use of goto was common in the early days of computing, but via the concerted effort of the structured programming movement in the 1960s and 1970s, that aimed to replace goto with more structured flow-control, its use has declined significantly. Nonetheless, goto is still used today, but generally limited to specific scenarios. The structured program theorem proved that the goto statement is not necessary to write programs that can be expressed as flow charts; some combination of the three programming constructs of sequence, selection, and iteration are sufficient for any computation that can be performed by a Turing machine, with the caveat that code duplication and additional variables may be required.
From Wikipedia, the free encyclopedia · View on Wikipedia